Color Fixer

Let’s get your colors back!

Some slicers open your custom 3D file but forget the colors you picked. Drop your file below and this page makes a copy that keeps every color. It all happens right here on your computer, and nothing gets uploaded anywhere.

Then, in Anycubic Slicer:

  1. 1
    Drag your new file (it ends in .obj) into Anycubic Slicer, just like you normally would.Or use File > Import if you prefer menus.
  2. 2
    A little window pops up saying it found your colors. Click OK.That’s the slicer saying “I see 2 colors, want them?” Yes you do!
  3. 3
    That’s it! Your model shows up painted. Check that each color points to the right filament slot, then slice and print like always.

Made with ♥ by Wacky McLovin Prints · Works with Anycubic Slicer Next, OrcaSlicer, and Bambu Studio